|
|
ACP 300 PSI Twin-Cylinder, 80 Gallon Industrial Air Compressor – 230 Volts AC / 1 Phase (With
manual, trouble shooting guide and periodic maintenance chart all in the
manual)
Updated
on 08-20-2007 @ 03:44 P.M. / CT
Item located in the 60803 Zip - Chicago Land, IL area. MORE
PICTURES
OF THIS ITEM? GO TO www.thombogo.com/bigblueaircompressor.htm ACP
STANDS FOR: AIR
COMPRESSOR
PRODUCTS,
INC. Model B51V84 Selling, “as is” - used. Also with magnetic starter mounted. Overall color is blue. Whole air compressor has been separated into five (5) pieces for easy pickup – unless if buyer would need seller to re-assemble this item (At no extra charge from seller). (605 pounds as stated on product shipping chart) If broken down into the five (5) pieces (As displayed in picture). - Weight and assembly - (From
using a bathroom scale) The air pump section – 217 Pounds The tank (With the electric box attached and cord) – 228.5 Pounds The two belts together – 3 Pounds The motor –90 Pounds The belt cage – 9.5 Pounds Seller will explain on how to reassemble during sale of this item or/and before pickup or during pickup (when or if bid is won). Please email seller through Ebay during your free time if or whenever needed. About five (5) pieces to put together unless if seller is needed for help for the assembly during pickup. All bolts and nuts are in places in their holes for re-assembly. Paint marks or patterns on the base above the tank section would indicate on how the motor and air pump section were mounted at the factory. Note: Pick-up only. Fairly clean exterior w/ some little natural rust spots here & there along with paint spots. No cracks or splits the both belts. Need to sell because of move – wouldn’t need for the next location. Other items in time will be here at this website for sale. - About other items - Yes, other items have been sold by, Sanactrade. May view at your own convenience. Note
- Only ratings about seller and the canceled item numbers will display. One
item had a negative issue - do to somewhat a handling problem during
shipment once it left at the shipping depot. It asked to be shipped back
for full refund, buyer refused and had asked for the money and still
wanted to keep the item anyway. Shipping depot was contacted for insurance
money for the item’s value to give back the buyer – Shipping depot
found ways to pass the buck around with-out handing the buck to the buyer.
Seller was in the middle however, did send money back to buyer. Motor was
returned before that. -
Age - Built
in 1992, purchased in 1993 for the amount of $1050.00
- letting it go at $375.00 @, “buy now” or bid regardless of
the seller having the original bill to display price if / when asked) - About where to go - http://www.air-compressor.com is the web page of who makes / deals with these types of products. http://www.air-compressor.com/mall/heavy_duty_industrial_compressor.asp is with-in the same website (up above) to display prices of the most recent models other there. Only
this added the compressor was a piece of aluminum stick about 10” long
to hold an extra air hose if needed. Great
for spray-painting cars, lacquering wood, staining wood, filling bike
tires (at low / reasonable pressure) auto, truck tires and more. Both
brass rings for the both air pipes are tape to avoid any pit marks or
other exposed foreign air elements to cause any negative harm to the rings
before the both unions are re-screwed back together. -
Techs - Gauge
Range: 0 – 300 The
electric cord is: six (6) feet long Air
pressure is set up to 150 PSI. CFM
Displacement: 22.3 @
175 PSI: 16.5 Tank
Gallon Size: 80 Gallons Tank
Configuration: Vertical Total
height - from the tank’s
base feet to the top side of the base plate above of the tank (With air
pump bolted down): 73.5 inches. / (With air pump removed): 53.5 inches
high. Depth
- from back edge of tank to front edge or front end of the aluminum stick
(to hold extra air hoses) : 27 inches. / (With the extender in – from
the rear edge of tank to the edge front of tank instead): 24 inches 24
inches is the diameter of tank itself. Circumference
of tank is 79 inches around. Width
is (If facing at the front side of the air compressor – from the left
edge of the street-L elbow pipe to the right edge of the BX wire on the
side of the electric switch): 35 inches. The
general volume if the air this item would be no more than about 3 feet
square by 7 feet high (63
cubic feet) – to store in vehicle during and after pickup. – Seller is
willing to help load this item into buyer’s vehicle. May the seller
suggest using a 2-wheeler / dolly to move the heavier pieces? – Seller
does have the equipment on hand for this. -
About the electric motor- Name:
Baldor industrial motor. (BALDOR
ELECTRIC CO.) (FT.
SMITH, ARK.) (MFD
IN U.S.A.) Cat
#: L1410T Spec:
36E02W849 Frame:
184T Ser:
F1029 HP:
5 Volts:
208 – 230 volts AC Amps:
25 (@ 208 volts AC) / 23 (@ 230 volts AC) – 220 volt outlet required. R.P.M.:
1,725 HZ:
60 Ser
F: 1.15 PH:
1 DES:
L P.F.
87% Code:
G Class:
F CASH
ONLY – Please. Seller is willing to re-assemble air compressor if or when seller is notified about this item being bought at the, “buynow” transaction and if buyer request for this item to be reassembled upon pickup. This item might take up to four to five hours to re-assemble - before pick-up, otherwise, if time span is shorter then that, seller will call / email buyer to come and pick-up. If buyer places the, "buynow" transaction, seller will wait if the buyer requests the re-assembly or not by emailing through the Ebay email system to the seller, if request is so by buyer, seller will begin right-away to assemble this item at no extra charge. Seller did have plans to move with this item and re-assemble however, no need for it in the next location. Selling instead.
NOTE / CAUTION - THIS ITEM IS VERY HEAVY WHEN ALL RE-ASSAMBLED BACK TOGETHER. CASH
ONLY & NO SHIPPING ON THIS ITEM - SORRY.
For more pictures / extended info, again, visit at www.thombogo.com/bigblueaircompressor.htm
Questions?
Contact me through the Ebay email system.
Thanks. Sanactrade. (08/20/2007)
|